what is the general rule for rigging equipment inspection regimn
A person submitted this question to Rosie's free generator. The asker's identity is neither imported nor published.
Rosie's answer
Published by SALUSTo ensure safe operation and prevent accidents, routine inspection of rigging equipment should be performed. Here are some guidelines to consider:
- Cranes and derricks should be inspected daily before use to ensure they are in good condition. [1]
Sources used for this answer
[1] MOSH Construction Checklist For Self-Inspection
Page 1
Open source documentSource excerpt
# MOSH ## To Employers & Workers: The rate of injury for workers in the construction industry is approximately 60 percent higher than the overall average for all workers. Recognition of hazards and their elimination is essential to prevention of job-related injuries. Listed on the following pages are are series of questions that persons working in construction should answer during a self inspection. The checklist has been designed to increase the knowledge and awareness of employees and employers. A general checklist for self-inspection for all industries is available and includes safety and health question on machines and equipment, electrical wiring, fire protection, environment and housekeeping, etc. For assistance or advice, On-Site Consultation Services are available to employers. Please call (410) 527-4472 for this free service. This publication is not intended to be legal interpre- tation of the provisions of "MOSH" Law or standards or to place any additional requirements on employ- ers or employees. ## Concrete YES NEEDS ACTION 1. Is formwork and shoring adequate to support all intended loads during concrete placement? ...... 2. Are protruding rebars covered or bent over where work must be performed overhead?. 3. Do employees wear gloves and eye protection during stripping operations?. 4. Are nails removed or bent over stripped forms?.. 5. Are clear pathways maintained through stripping areas?... CEMENT # CONSTRUCTION CHECKLIST FOR SELF-INSPECTION <table><tr><th></th><th>Cranes</th><th>YES NEEDS ACTION</th></tr><tr><td>1.</td><td>Are cranes and derricks restricted from operating within 20 feet of any electrical power line?...</td><td></td></tr><tr><td>2.</td><td>Are rated capacities, operating speed, and instructions posted and visible to the operator?....</td><td></td></tr><tr><td>3.</td><td>Does the operator understand and use the load chart?</td><td></td></tr><tr><td>4.</td><td>Is the operator able to determine the angle and length of the …