Skip to content
All safety questions
Asked by a personGeneral — US and Canadaen-CA

How much solution should be used to neutralize 14 gallons of acid

A person submitted this question to Rosie's free generator. The asker's identity is neither imported nor published.

Rosie's answer

Published by SALUS

I am unable to determine the exact amount of solution needed to neutralize 14 gallons of acid. The amount of neutralizing solution depends on the concentration and type of acid, as well as the neutralizing agent used. For example, when working with concentrated aqueous ammonia solution, the volume needed to generate 1000 ppm in a test area can be calculated by multiplying the test area volume (in cubic feet) by 0.2 milliliters of concentrated aqueous ammonia solution per cubic foot of test area volume [1].

To ensure safety, it is important to:

  1. Consult the Safety Data Sheet (SDS) for the specific acid to determine appropriate neutralizing agents and procedures.
  2. Establish written safe work procedures for spill response, and ensure employees are trained in these procedures [2].
  3. Wear appropriate personal protective equipment (PPE), such as gloves, eye protection, and protective clothing, to prevent skin contact or splashes [3].
  4. Provide adequate ventilation to avoid exposure to hazardous vapors 8, 20.
  5. Have a supply of clean, cold water readily available for washing off any liquids from the skin or clothing [4].

Always prioritize safety and consult with a qualified professional for specific guidance on neutralizing acids.

4 source record(s)

Sources used for this answer

[1] General Regulation (N.B. Reg. 91-191)

Page 301

Open source document

Source excerpt

opened, or another equally effective means is used to prevent employees from accessing the spinning rotor. tout aussi efficace permet de prévenir l'accès des sala -riés aux rotors qui tournent. 2022-79 ## General 2022-79 ## Safety procedures - hazardous operations 2022-79 342.7 With respect to hazardous operations, an em -ployer shall ensure that - (a) written safe work procedures for hazardous op -erations, including spill response, are established, - (b) employees are adequately instructed and trained in the safe work procedures for hazardous operations, and - (c) employees follow the safe work procedures for hazardous operations. 2022-79 ## Fire protection 2022-79 342.71 An employer shall ensure that suitable fire ex -tinguishers are accessible at all times in a laboratory where flammable substances are used or stored. 2022-79 ## Movement of containers 2022-79 342.72 An employer shall ensure that a container of hazardous substances that is moved within a laboratory is moved in a manner that does not damage the con -tainer. 2022-79; 2024-38 ## Personal protection 2022-79 342.8 With respect to the protection of employees, an employer shall ensure that 2022-79 ## Généralités 2022-79 ## Procédures de sécurité - opérations dangereuses 2022-79 342.7 En ce qui à trait aux opérations dangereuses, l'employeur s'assure de ce qui suit : - a) il établit des procédures écrites de travail sécuri -taire pour les opérations dangereuses, y compris les déversements; - b) les salariés reçoivent une formation adéquate sur ces procédures; - c) les salariés suivent ces procédures. 2022-79 ## Protection contre l'incendie 2022-79 342.71 L'employeur s'assure que des extincteurs d'in -cendie convenables sont disponibles en tout temps dans tout laboratoire où des substances inflammables sont utilisées ou entreposées. 2022-79 ## Déplacement de récipients 2022-79 342.72 L'employeur s'assure que le dépla

[2] Rules for the Administration of the Oregon Safe Employment Act (Construction, Division 3, OSHA Oregon)

Page 154

Open source document

Source excerpt

Division 3 AO 3-2019 Oregon Administrative Rules Oregon Occupational Safety and Health Division - (iii) All persons required to handle work wet with a liquid other than water shall be provided with gloves impervious to such a liquid and of a length sufficient to prevent entrance of liquid into the tops of the gloves. The interior of gloves shall be kept free from corrosive or irritating contaminants. - (iv) All persons required to work in such a manner that their clothing may become wet shall be provided with such aprons, coats, jackets, sleeves, or other garments made of rubber, or of other materials impervious to liquids other than water, as are required to keep their clothing dry. Aprons shall extend well below the top of boots to prevent liquid splashing into the boots. Provision of dry, clean, cotton clothing along with rubber shoes or short boots and an apron impervious to liquids other than water shall be considered a satisfactory substitute where small parts are cleaned, plated, or acid dipped in open tanks and rapid work is required. - (v) Whenever there is a danger of splashing, for example, when additions are made manually to the tanks, or when acids and chemicals are removed from the tanks, the employees so engaged shall be required to wear either tight-fitting chemical goggles or an effective face shield. See 1926.102. - (vi) When, during the emergencies specified in paragraph (i)(11)(v) of this section, employees must be in areas where concentrations of air contaminants are greater than the limits set by paragraph (i)(2)(iii) of this section or oxygen concentrations are less than 19.5 percent, they must use respirators that reduce their exposure to a level below these limits or that provide adequate oxygen. Such respirators must also be provided in marked, quickly accessible storage compartments built for this purpose when the possibility exists of accidental release of hazardous concentrations of air contaminants. Respirators must be approved by N

[3] Rules for the Administration of the Oregon Safe Employment Act (General Occupational Safety and Health, Division 2, OSHA Oregon)

Page 699

Open source document

Source excerpt

Oregon Occupational Safety and Health Division Oregon Administrative Rules Division 2 ## 5.0 - Safety precautions - 5.1 Concentrated aqueous ammonium hydroxide, NH 4 OH, is a corrosive volatile liquid requiring eye, skin, and respiratory protection. The person conducting the test shall review the MSDS for aqueous ammonia. - 5.2 Since the established permissible exposure limit for ammonia is 35 ppm as a 15 minute STEL, only persons wearing a positive pressure self-contained breathing apparatus or a positive pressure supplied air respirator shall be in the chamber. Normally only the person wearing the totally-encapsulating suit will be inside the chamber. A stand-by person shall have a positive pressure self-contained breathing apparatus, or a positive pressure supplied air respirator available to enter the test area should the suited individual need assistance. - 5.3 A method to monitor the suited individual must be used during this test. Visual contact is the simplest but other methods using communication devices are acceptable. - 5.4 The test room shall be large enough to allow the exercise protocol to be carried out and then to be ventilated to allow for easy exhaust of the ammonia test atmosphere after the test(s) are completed. - 5.5 Individuals shall be medically screened for the use of respiratory protection and checked for allergies to ammonia before participating in this test procedure. ## 6.0 - Test procedure - 6.1.1 Measure the test area to the nearest foot and calculate its volume in cubic feet. Multiply the test area volume by 0.2 milliliters of concentrated aqueous ammonia solution per cubic foot of test area volume to determine the approximate volume of concentrated aqueous ammonia required to generate 1000 ppm in the test area. - 6.1.2 Measure this volume from the supply of concentrated aqueous ammonia and place it into a closed plastic container. - 6.1.3 Place the container, several high range ammonia detector tubes, and the pump in the clean t

[4] Rules for the Administration of the Oregon Safe Employment Act (Construction, Division 3, OSHA Oregon)

Page 155

Open source document

Source excerpt

Oregon Occupational Safety and Health Division Oregon Administrative Rules AO 3-2019 Division 3 - (vii) Near each tank containing a liquid which may burn, irritate, or otherwise be harmful to the skin if splashed upon the worker's body, there shall be a supply of clean cold water. The water pipe (carrying a pressure not exceeding 25 pounds (11.325 kg)) shall be provided with a quick opening valve and at least 48 inches (1.216 m) of hose not smaller than threefourths inch, so that no time may be lost in washing off liquids from the skin or clothing. Alternatively, deluge showers and eye flushes shall be provided in cases where harmful chemicals may be splashed on parts of the body. - (viii) Operators with sores, burns, or other skin lesions requiring medical treatment shall not be allowed to work at their regular operations until so authorized by a physician. Any small skin abrasions, cuts, rash, or open sores which are found or reported shall be treated by a properly designated person so that chances of exposures to the chemicals are removed. Workers exposed to chromic acids shall have a periodic examination made of the nostrils and other parts of the body, to detect incipient ulceration. - (ix) Sufficient washing facilities, including soap, individual towels, and hot water, shall be provided for all persons required to use or handle any liquids which may burn, irritate, or otherwise be harmful to the skin, on the basis of at least one basin (or its equivalent) with a hot water faucet for every 10 employees. See 1926.51(f). - (x) Locker space or equivalent clothing storage facilities shall be provided to prevent contamination of street clothing. - (xi) First aid facilities specific to the hazards of the operations conducted shall be readily available. - (10) Special precautions for cyanide. Dikes or other arrangements shall be provided to prevent the possibility of intermixing of cyanide and acid in the event of tank rupture. - (11) Inspection, maintenance, and

Related Q&A

Keep exploring.

Human questionGeneral

Warehouse safety

Warehouse Safety Regulations and Hazard Prevention ================================================== *Date:** 2025-08-21 *Duration:** \[DURATION] minutes *Presenter:** \[PRESENTER NAME] *Location:** \[LOCATION] Objective The objective of this toolbox talk is to ensure all personnel understand warehouse safety

Read the thread
Human questionGeneral

Rope

Toolbox Talk: Safe Use of Ropes on Construction Sites *Date:** [DATE] *Duration:** [DURATION] minutes *Presenter:** [PRESENTER NAME] *Location:** [LOCATION] Objective The objective of this toolbox talk is to educate workers on the safe use of ropes in construction, focusing on hazard identification, proper inspection

Read the thread
Human questionGeneral

Write a risk assessment for Aspirin content back titration

A suitable risk assessment and laboratory safety procedure for aspirin determination by back titration should treat the work as a corrosive chemical handling task with splash, inhalation, glassware, and spill hazards. Before starting, complete a task-specific COSHH/PPE hazard assessment, review the SDS for all

Read the thread
Human questionGeneral

Write a toolbox talk on battery augmentation construction

Toolbox Talk: Battery Augmentation Construction *Date:** [DATE] *Duration:** [DURATION] minutes *Presenter:** [PRESENTER NAME] *Location:** [LOCATION] Objective The objective of this toolbox talk is to educate participants on the safe handling and installation of batteries during augmentation construction projects. By

Read the thread
Human questionGeneral

Write a toolbox talk on summer

Summer Safety: Heat Stress, Hydration, Sun Exposure, and Outdoor Work Hazards ============================================================================= *Date:** 2026-07-23 *Duration:** \[DURATION] minutes *Presenter:** \[PRESENTER NAME] *Location:** \[LOCATION] Objective To help workers recognize heat-related

Read the thread
Human questionGeneral

Printer usage

Printer Safety: Operation and Maintenance ========================================= *Date:** 2025-08-25 *Duration:** \[DURATION] minutes *Presenter:** \[PRESENTER NAME] *Location:** \[LOCATION] Objective The objective of this talk is to ensure all personnel understand the potential hazards involved in printer operation

Read the thread
Discussion thread

Add your experience.

Community answers can add practical context. They are moderated, but they are not SALUS-reviewed safety guidance.

New contributions are temporarily closed while the moderation queue is configured.

Community answers(0)

No community answers have been approved yet.

Comments on Rosie's answer(0)

No comments have been approved yet.

Ready to put operational safety to work?

Join 400K users across 150K sites already on SALUS.

No commitment · 30-minute personalized walkthrough