Is 100% rubber boots acid resistance?
A person submitted this question to Rosie's free generator. The asker's identity is neither imported nor published.
Rosie's answer
Published by SALUSWhile 100% rubber boots can offer a degree of protection against certain chemicals, their acid resistance depends on the type of rubber and the concentration and type of acid [1]. Not all rubber compounds are suitable for all acids. For handling work wet with liquids other than water, ensure you have gloves impervious to the liquid and of sufficient length to prevent liquid entry [1]. If clothing may become wet, aprons, coats, jackets, or sleeves made of rubber or other liquid-impervious materials should be provided [1]. Aprons should extend below the top of the boots to prevent splashes [1].
For protection against specific chemicals, it's important to check the manufacturer's specifications for the boots to ensure they are rated for the acid you are working with. In some cases, you may need chemical-resistant steel toe and shank boots or disposable boot covers [2].
Sources used for this answer
[1] Rules for the Administration of the Oregon Safe Employment Act (General Occupational Safety and Health, Division 2, OSHA Oregon)
Page 705
Open source documentSource excerpt
Oregon Occupational Safety and Health Division Oregon Administrative Rules - 6. Boots, outer, chemical-resistant steel toe and shank. - 7. Boot-covers, outer, chemical-resistant (disposable). 1 - 8. Hard hat. 1 - 9. (Reserved) - 10. Face shield. 1 - III. Level C - The concentration(s) and type(s) of airborne substance(s) is known and the criteria for using air purifying respirators are met. The following constitute Level C equipment; it may be used as appropriate. - 1. Full-face or half-mask, air-purifying respirators (NIOSH approved). - 2. Hooded chemical-resistant clothing (overalls; two-piece chemical-splash suit; disposable chemical-resistant overalls). - 3. Coveralls. 1 - 4. Gloves, outer, chemical-resistant. - 5. Gloves, inner, chemical-resistant. - 6. Boots (outer), chemical-resistant steel toe and shank. 1 - 7. Boot-covers, outer, chemical-resistant (disposable). 1 - 8. Hard hat. 1 - 9. Escape mask. 1 - 10. Face shield. 1 - IV. Level D - A work uniform affording minimal protection, used for nuisance contamination only. - The following constitute Level D equipment; it may be used as appropriate: - 1. Coveralls. - 2. Gloves. 1 - 3. Boots/shoes, chemical-resistant steel toe and shank. - 4. Boots, outer, chemical-resistant (disposable). 1 1 Optional, as applicable AO 3-2019 Division 2
[2] Rules for the Administration of the Oregon Safe Employment Act (Construction, Division 3, OSHA Oregon)
Page 154
Open source documentSource excerpt
Division 3 AO 3-2019 Oregon Administrative Rules Oregon Occupational Safety and Health Division - (iii) All persons required to handle work wet with a liquid other than water shall be provided with gloves impervious to such a liquid and of a length sufficient to prevent entrance of liquid into the tops of the gloves. The interior of gloves shall be kept free from corrosive or irritating contaminants. - (iv) All persons required to work in such a manner that their clothing may become wet shall be provided with such aprons, coats, jackets, sleeves, or other garments made of rubber, or of other materials impervious to liquids other than water, as are required to keep their clothing dry. Aprons shall extend well below the top of boots to prevent liquid splashing into the boots. Provision of dry, clean, cotton clothing along with rubber shoes or short boots and an apron impervious to liquids other than water shall be considered a satisfactory substitute where small parts are cleaned, plated, or acid dipped in open tanks and rapid work is required. - (v) Whenever there is a danger of splashing, for example, when additions are made manually to the tanks, or when acids and chemicals are removed from the tanks, the employees so engaged shall be required to wear either tight-fitting chemical goggles or an effective face shield. See 1926.102. - (vi) When, during the emergencies specified in paragraph (i)(11)(v) of this section, employees must be in areas where concentrations of air contaminants are greater than the limits set by paragraph (i)(2)(iii) of this section or oxygen concentrations are less than 19.5 percent, they must use respirators that reduce their exposure to a level below these limits or that provide adequate oxygen. Such respirators must also be provided in marked, quickly accessible storage compartments built for this purpose when the possibility exists of accidental release of hazardous concentrations of air contaminants. Respirators must be approved by N…
Keep exploring.
Create a safe work procedure for sanding and painting drywall
Safe Work Procedure: Sanding and Painting Drywall Document Number: [SWP-NUMBER] Revision Date: [DATE] Next Review Date: [NEXT REVIEW DATE] Department: [DEPARTMENT NAME] 1. Scope This Safe Work Procedure (SWP) outlines the necessary safety precautions and procedures for sanding and painting drywall in construction
Read the threadWhat safety education does a garden center merchandiser need
A garden center merchandiser needs safety education to protect themselves from workplace hazards. This includes understanding hazard communication, handling hazardous chemicals, and emergency procedures 2, 4. Training should cover how to detect hazardous chemicals, understand their physical and health hazards, and
Read the threadInstalling pipe spools with straps and crane
Safe Work Procedure: Installing Pipe Spools with Straps and Crane Document Number: [SWP-NUMBER] Revision Date: [DATE] Next Review Date: [NEXT REVIEW DATE] Department: [DEPARTMENT NAME] 1. Scope This Safe Work Procedure (SWP) outlines the necessary safety requirements and procedures for the safe installation of pipe
Read the threadSewer manhole
Toolbox Talk: Sewer Manhole Safety *Date:** [DATE] *Duration:** [DURATION] minutes *Presenter:** [PRESENTER NAME] *Location:** [LOCATION] Objective This toolbox talk aims to educate workers on the hazards associated with sewer manhole entry and the necessary safety procedures to mitigate those risks. By the end of this
Read the threadWorksite injury Management Program
Safe Work Procedure: Worksite Injury Management Program Document Number: [SWP-NUMBER] Revision Date: [DATE] Next Review Date: [NEXT REVIEW DATE] Department: [DEPARTMENT NAME] 1. Scope This procedure covers the management of worksite injuries, including the immediate response, reporting, investigation, and follow-up
Read the threadI'm looking to build a hand protection policy and recommend gloves for my construction company.
To create a hand protection policy and recommend gloves for your construction company, consider these points: Assess Workplace Hazards: Evaluate the specific tasks performed by your employees and identify potential hand hazards such as cuts, abrasions, punctures, chemical exposures, and temperature extremes 3, 6, 9.
Read the threadAdd your experience.
Community answers can add practical context. They are moderated, but they are not SALUS-reviewed safety guidance.
New contributions are temporarily closed while the moderation queue is configured.
Community answers(0)
No community answers have been approved yet.
Comments on Rosie's answer(0)
No comments have been approved yet.