whats pass mark of CRST exam

Source excerpt

# Testing. The written and practical tests must be either: (cont.) ## 1926.1427(f)(7) (cont.) [Reserved] 1926.1427(h) Language and literacy requirements. 1926.1427(h)(1) Tests under this section may be administered verbally, with answers given verbally, where the operator candidate: 1926.1427(h)(1)(i) Passes a written demonstration of literacy relevant to the work. 1926.1427(h)(1)(ii) Demonstrates the ability to use the type of written manufacturer procedures applicable to the class/type of equipment for which the candidate is seeking certification. 1926.1427(h)(2). Tests under this section may be administered in any language the operator candidate understands, and the operator's certification documentation must note the language in which the test was given. The operator is only permitted to operate equipment that is furnished with materials required by this subpart, such as operations manuals and load charts, that are written in the language of the certification. 1926.1427(i) [Reserved] ## 1926.1427(j) Certification criteria. Certifications must be based on the following: 1926.1427(j)(1) A determination through a written test that: 1926.1427(j)(1)(i) The individual knows the information necessary for safe operation of the specific type of Submit Feedback

Source excerpt

# equipment the individual will operate, including all of the following: 1926.1427(j)(1)(i)(A) The controls and operational/performance characteristics. 1926.1427(j)(1)(i)(B) Use of, and the ability to calculate (manually or with a calculator), load/capacity information on a variety of configurations of the equipment. 1926.1427(j)(1)(i)(C) Procedures for preventing and responding to power line contact. 1926.1427(j)(1)(i)(D) Technical knowledge of the subject matter criteria listed in appendix C of this subpart applicable to the specific type of equipment the individual will operate. Use of the appendix C criteria meets the requirements of this provision. 1926.1427(j)(1)(i)(E) Technical knowledge applicable to the suitability of the supporting ground and surface to handle expected loads, site hazards, and site access. ## 1926.1427(j)(1)(i)(F) This subpart, including applicable incorporated materials. 1926.1427(j)(1)(ii) The individual is able to read and locate relevant information in the equipment manual and other materials containing information referred to in paragraph (j)(1)(i) of this section. - 1926.1427(j)(2) A determination through a practical test that the individual has the skills necessary for safe operation of the equipment, including the following: 1926.1427(j)(2)(i) Ability to recognize, from visual and auditory observation, the items listed in $ 1926.1412(d) Submit Feedback

Source excerpt

# equipment the individual will operate, including all of the following: (cont.) ## 1926.1427(j)(1)(i)(F) (cont.) (shift inspection). 1926.1427(j)(2)(ii) Operational and maneuvering skills. 1926.1427(j)(2)(iii) Application of load chart information. 1926.1427(j)(2)(iv) Application of safe shut-down and securing procedures. 1926.1427(k) Effective dates. 1926.1427(k)(1) Apart from the evaluation and documentation requirements in paragraphs (a) and (f), this section is effective on December 10, 2018. ## 1926.1427(k)(2) The evaluation and documentation requirements in paragraphs (a) and (f) are effective on February 7, 2019. [75 FR [redacted postal code], August 9, 2010; 79 FR [redacted postal code], September 26, 2014; 82 FR [redacted postal code], November 9, 2017; 83 FR [redacted postal code]-[redacted postal code], November 9, 2018] Scroll to Top + OSHA Standards Enforcement Topics Media Center Contact Us DIPARTMENT OF LABOR UNITED STATES OF AMERICA Submit Feedback

Source excerpt

# TABLE D-65.1 MINIMUM ILLUMINATION INTENSITIES IN FOOT-CANDLES (cont.) ## 1926.65(q)(6) (cont.) 1926.65(q)(6)(v)(C) Know and understand the hazards and risks associated with employees working in chemical protective clothing. 1926.65(q)(6)(v)(D) Know how to implement the local emergency response plan. 1926.65(q)(6)(v)(E) Know of the state emergency response plan and of the Federal Regional Response Team. 1926.65(q)(6)(v)(F) Know and understand the importance of decontamination procedures. - 1926.65(q)(7) Trainers. Trainers who teach any of the above training subjects shall have satisfactorily completed a training course for teaching the subjects they are expected to teach, such as the courses offered by the U.S. National Fire Academy, or they shall have the training and/or academic credentials and instructional experience necessary to demonstrate competent instructional skills and a good command of the subject matter of the courses they are to teach. ## 1926.65(q)(8) ## Refresher training. 1926.65(q)(8)(i) Those employees who are trained in accordance with paragraph (q)(6) of this section shall receive annual refresher training of sufficient content and duration to maintain their competencies, or shall demonstrate competency in those areas at least yearly. - 1926.65(q)(8)(ii) A statement shall be made of the training or competency, and if a statement of competency is made, the employer shall keep a record of the methodology used to demonstrate competency. - 1926.65(q)(9) - Medical surveillance and consultation. - 1926.65(q)(9)(i) Members of an organized and designated HAZMAT team and hazardous materials specialists shall receive a baseline physical examination and be provided with medical surveillance as Submit Feedback

Source excerpt

# TABLE D-65.1 MINIMUM ILLUMINATION INTENSITIES IN FOOT-CANDLES (cont.) ## 1926.65(q)(6) (cont.) Know the classification, identification and verification of known and unknown materials by using field survey instruments and equipment. 1926.65(q)(6)(iii)(C) Be able to function within an assigned role in the Incident Command System. 1926.65(q)(6)(iii)(D) Know how to select and use proper specialized chemical personal protective equipment provided to the hazardous materials technician. 1926.65(q)(6)(iii)(E) Understand hazard and risk assessment techniques. 1926.65(q)(6)(iii)(F) Be able to perform advance control, containment, and/or confinement operations within the capabilities of the resources and personal protective equipment available with the unit. 1926.65(q)(6)(iii)(G) Understand and implement decontamination procedures. 1926.65(q)(6)(iii)(H) Understand termination procedures. - 1926.65(q)(6)(iii)(I) Understand basic chemical and toxicological terminology and behavior. - 1926.65(q)(6)(iv) Hazardous materials specialist. Hazardous materials specialists are individuals who respond with and provide support to hazardous materials technicians. Their duties parallel those of the hazardous materials technician, however, those duties require a more directed or specific knowledge of the various substances they may be called upon to contain. The hazardous materials specialist would also act as the site liaison with Federal, state, local and other government authorities in regards to site activities. Hazardous materials specialists shall have received at least 24 hours of training equal to the technician level and in addition have competency in the following areas and the employer shall so certify: 1926.65(q)(6)(iv)(A) Know how to implement the local emergency response plan. Submit Feedback

Source excerpt

# TABLE D-65.1 MINIMUM ILLUMINATION INTENSITIES IN FOOT-CANDLES (cont.) ## 1926.65(q)(6) (cont.) at least eight hours of training or have had sufficient experience to objectively demonstrate competency in the following areas in addition to those listed for the awareness level and the employer shall so certify: - 1926.65(q)(6)(ii)(A) - Knowledge of the basic hazard and risk assessment techniques. 1926.65(q)(6)(ii)(B) Know how to select and use proper personal protective equipment provided to the first responder operational level. - 1926.65(q)(6)(ii)(C) An understanding of basic hazardous materials terms. 1926.65(q)(6)(ii)(D) Know how to perform basic control, containment and/or confinement operations within the capabilities of the resources and personal protective equipment available with their unit. - 1926.65(q)(6)(ii)(E) Know how to implement basic decontamination procedures. - 1926.65(q)(6)(ii)(F) An understanding of the relevant standard operating procedures and termination procedures. - 1926.65(q)(6)(iii) Hazardous materials technician. Hazardous materials technicians are individuals who respond to releases or potential releases for the purpose of stopping the release. They assume a more aggressive role than a first responder at the operations level in that they will approach the point of release in order to plug, patch or otherwise stop the release of a hazardous substance. Hazardous materials technicians shall have received at least 24 hours of training equal to the first responder operations level and in addition have competency in the following areas and the employer shall so certify: 1926.65(q)(6)(iii)(A) Know how to implement the employer's emergency response plan. 1926.65(q)(6)(iii)(B) Submit Feedback

Source excerpt

# 1926.1412 INSPECTIONS (cont.) ## 1926.1427 OPERATOR TRAINING, CERTIFICATION, AND EVALUATION (cont.) 1926. 1427(e)(5)(i) No operator is qualified until the auditor confirms that the deficiency has been corrected. 1926. .1427(e)(5)(ii) The program is audited again within 180 days of the confirmation that the deficiency was corrected. 1926.1427(e)(5)(iii) The auditor files a documented report of the deficiency to the appropriate Regional Office of the Occupational Safety and Health Administration within 15 days of the auditor's determination that there is a deficiency. 926.1427(e)(5)(iv) Records of the audits of the employer's program are maintained by the auditor for 3 years and are made available by the auditor to the Secretary of Labor or the Secretary's designated representative upon request. 1926.1427(e)(6) Audited-program certificates. A certification under this paragraph is: 1926. 1427(e)(6)(i) Not portable: Such a certification meets the requirements of paragraph (c) of this section only where the operator is employed by (and operating the equipment for) the employer that issued the certification. 1926.1427(e)(6)(ii) Valid for 5 years. ## 1926.1427(f) Evaluation. 1926.1427(f)(1) Through an evaluation, the employer must ensure that each operator is qualified by a demonstration of: 926.1427(f)(1)(i) The skills and knowledge, as well as the ability to recognize and avert risk, necessary to operate the equipment safely, including those specific to the safety devices, operational aids, software, and the size and configuration of the equipment. Size and configuration includes, but is not limited to, lifting capacity, boom length, attachments, luffing jib, and counterweight set-up. 1926.1427(f)(1)(ii) The ability to perform the hoisting activities required for assigned work, including, if applicable, blind lifts, personnel hoisting, and multi-crane lifts. 1926.1427(f)(2) For operators employed prior to December 10, 2018, the employer may rely on its previous…

Source excerpt

# TABLE D-65.1 MINIMUM ILLUMINATION INTENSITIES IN FOOT-CANDLES (cont.) ## 1926.65(q)(6) (cont.) - 1926.65(q)(6)(iv)(B) Understand classification, identification and verification of known and unknown materials by using advanced survey instruments and equipment. - 1926.65(q)(6)(iv)(C) Know of the state emergency response plan. 1926.65(q)(6)(iv)(D) Be able to select and use proper specialized chemical personal protective equipment provided to the hazardous materials specialist. 1926.65(q)(6)(iv)(E) Understand in-depth hazard and risk techniques. 1926.65(q)(6)(iv)(F) Be able to perform specialized control, containment, and/or confinement operations within the capabilities of the resources and personal protective equipment available. 1926.65(q)(6)(iv)(G) Be able to determine and implement decontamination procedures. 1926.65(q)(6)(iv)(H) Have the ability to develop a site safety and control plan. 1926.65(q)(6)(iv)(I) Understand chemical, radiological and toxicological terminology and behavior. - 1926.65(q)(6)(v) On scene incident commander. Incident commanders, who will assume control of the incident scene beyond the first responder awareness level, shall receive at least 24 hours of training equal to the first responder operations level and in addition have competency in the following areas and the employer shall so certify: 1926.65(q)(6)(v)(A) Know and be able to implement the employer's incident command system. 1926.65(q)(6)(v)(B) Know how to implement the employer's emergency response plan. Submit Feedback